Tired of the endless wait for the kettle to boil and the bottle to cool? Wish making a formula feed was quicker and less faff, especially during those sleepy night feeds? Well, say hello to the RapidTeam, your new dream team for speedy formula feeds, following NHS guidelines.
Our formula feeding trio, RapidHot, RapidCool and RapidSterilise, is here to save the day and your sanity.
- RapidHot gives you instant filtered boiling water at your baby’s exact feed size
- RapidCool cools your formula feed to the perfect temperature in just 2 minutes*
- RapidSterilise takes care of sterilising your RapidCool in a flash using UV light no water no chemicals no hassle
Ready to get started? Here’s how to make a formula bottle with the RapidTeam.
What you will need:
- RapidHot
- RapidCool with digital lid and stand
- Milk powder dispenser (included)
- Your chosen formula powder
- Baby bottle
- RapidSterilise
Step by step guide to make a formula feed with the RapidTeam
1. Fill the milk powder dispenser (included with your RapidCool) with your chosen formula.
2. Turn off the child lock by pressing and holding the child lock button.
3. Put your RapidCool on the stand, underneath the water dispenser.
4. Use the arrows next to the volume icon to choose the right amount of water for your baby’s feed.
5. Press the boiling water icon, unlock the child lock again, then press the water drop button to pour in the boiling water.
6. Add your formula powder using the dispenser.
7. Screw the digital lid onto the RapidCool and give it a good shake to mix everything.
8. Turn the RapidCool upside down for at least five seconds. This helps the thermometer check the temperature.
9. Tap the circle on the lid to turn on the Nuby logo.
10. When the logo turns green, the feed is ready. Pour it into your baby’s bottle.
11. Always test the milk on the inside of your wrist to make sure it’s not too hot before feeding your baby.
How to sterilise your RapidCool using RapidSterilise
1. Take off both lids from the RapidSterilise and open the lid on your RapidCool.
2. Place the RapidCool lid into the lid section of the RapidSterilise. Make sure the edge of the lid is touching Sensor 1.
3. Put the RapidSterilise over the RapidCool flask so that the neck of the flask is lined up with the middle of Sensor 2.
4. Press the button on the RapidSterilise to start. The blue light will flash while it’s working.
5. After one minute, it will turn off by itself.
Ready to make formula feeding quicker, easier and stress free? Shop our full RapidTeam range.